Punch use safety procedures
Semi-auto Sealing And Shrinking Series The semi-automatic cuff shrinking machine is composed of a sealing and cutting machine and a BSE series heat shrinkable packaging machine. It uses a variety of imported and domestic heat shrinkable films such as PE as packaging materials. After sealing and cutting, the products directly enter the heat shrinkable packaging machine to complete packaging, which greatly improves the working efficiency and reduces the power consumption. The main electrical components of the cuff shrinking machine are imported high-quality components, and the actuating part is high-quality pneumatic components, so the operation becomes extremely simple, the performance is very stable, the failure rate is extremely low, and the service life is longer. It can work continuously for a long time and can meet the requirements of mass production. Semi-auto Sealing And Shrinking Series,Semi Auto Sealing And Shrinking Series,Semi-auto Sealing And Shrink Series SUZHOU SHENGBAIWEI PACKAGING EQUIPMENT CO.,LTD , https://www.sbwpack.com
Second, the empty aircraft test run, to confirm the brakes, clutches, operators, appliances and other parts of the action is flexible, accurate and reliable, and make several empty trips to confirm whether its kinetic energy is good.
Third, recognize the rotation direction of the large-wheel motor, before starting the machine, is strictly prohibited. (In manual mode, you can manually reverse the return).
4. When the machine tool is working, it is not allowed to put two sheets at the same time. When punching small pieces, safety tools should be used. It is forbidden to overload the work. It is forbidden to work under the condition that the fuse is damaged. Do not remove guards and other protective devices.
5. It is forbidden to place the foot on the footboard when it is not working, and it is strictly forbidden to change the position of the part after the treadle is stepped on.
Six, mold installation should ensure that the mold center and machine center are the same.
7. If it is found that the machine tool is not working properly, it should immediately stop working, turn off the power supply, and then start troubleshooting after troubleshooting.
VIII. The machine tool will be filled with lubricant once within 2 hours of continuous operation.