Shanghai Jiashi strives to promote the transformation and upgrade of the moisture analyzer industry
Shanghai Jiashi strives to promote the transformation and upgrade of the moisture analyzer industry Moisture detector preferred Shanghai Jiashi, the appearance of simple, good visual effects. Shanghai Jiashi Electronic Technology Co., Ltd. moisture meter manufactured to carry all kinds of scenes, the operation more simple, clean. Contaminants can weaken the defense of the epidermis, reduce the moisturizing ability of the skin, cause dryness of the skin, and further cause skin discomfort. It can be measured on the reel, or it can be measured on the paper basket. "That is to say, this instrument is rare regardless of strength, so it will attract worldwide attention. When drying the sample, during the drying process, the moisture meter continuously measures and immediately displays the lost moisture content of the sample. After the drying process is completed, the final measured moisture content is locked. Compared with the international oven heating method, halogen heating can quickly and uniformly dry the sample at high temperature, and the sample surface is not easily damaged. The detection results are in good agreement with the national standard oven method, and it is replaceable, and the detection efficiency is much higher. In the oven method. General samples take only a few minutes to complete the measurement. The MS-100 and MS-100A Lushun Moisture Analyzers manufactured by Shanghai Jiashi are simple to operate and test accurately. The LCD display is used in the display section to make the screen clearer and brighter. The display values ​​are clearly visible, and the moisture values ​​can be displayed separately. Value, final value, measurement time, initial value of temperature, final value and other data, and has the connection function with computer and printer. Foshan Laijian Fitness Equipment Co., Ltd. , https://www.fullgymequipment.com
Moisture content is an important factor affecting the processing technology, product appearance, and product characteristics of resins such as polyamide (PA) and polycarbonate (PC). In the injection molding process, if you use plastic particles with too much moisture to produce, there will be some