Car service maintenance is the key
NINGBO YUNCAI CHEMICAL CO.,LIMITED , https://www.win-chemical.com
There are two main aspects of vehicle maintenance. One is the mandatory maintenance provided by the maintenance station. On the other hand, some daily maintenance of the owner himself. The normal maintenance of the vehicle relates to the service life of the vehicle and the safety of the driver. Improper maintenance or use can cause vehicle failures and pose safety hazards. Therefore, in addition to carrying out mandatory maintenance at our repair station on time, you should also perform daily maintenance work, which is beneficial to the "health" of the vehicle. Many users of Hainan Mazda's vehicles have not experienced major faults in good driving conditions after 600,000 kilometers, benefiting from careful daily maintenance.
After the purchase of the car, please read the "Product Quality Assurance" and "Operating Instructions" attached to the vehicle carefully. The detailed instructions for use and maintenance are provided in the "User's Manual". You should carefully read and follow them to ensure that the vehicle is always In good use. The following brief introduction to vehicle maintenance knowledge, hoping to provide you with some help.
First, the engine oil check will park the vehicle on the level of the road. Pull out the vernier to check the amount of oil. If the oil is within the two markings (F) and (L), it is within the normal range, if it is lower than the (L) position. The specified model should be added. The level after refueling must not be higher than (F).
Second, the engine coolant liquid surface check the engine in the heat state, do not open the radiator cover, otherwise it may be spilled coolant or high temperature steam burns. After the engine is cooled, check that the liquid level of the coolant is between the full and low levels. Otherwise, add distilled water or purified water (not with mineral water) or frozen liquid. The height of the liquid after adding water cannot exceed the full level. If it is found that the cooling liquid is quickly reduced in a short time, check the cooling system for leaks or go to the service station for inspection.
Third, the brake fluid level inspection brake is also normal between high and low positions. If the brake fluid is close to the lower limit or lower than the lower limit, it indicates that there may be a leak in the system or the brake shoe wears too much. The maintenance station should be promptly repaired.
When adding brake fluid, be careful to add the same type of brake fluid to prevent damage to the bowl. Pay attention to protecting the paint from corrosion.
Fourth, the clutch master cylinder fluid level check The clutch fluid level between the high and low fluid level is normal, if lower than the standard line, it may be the main pump or pump cylinder damage. In the running state of the engine, it will be difficult to file or unable to file. Please visit the nearest service station immediately.
Fifth, the battery maintenance check Check the battery is fixed, the electrolyte should be between the upper and lower limits, close to the lower line should be added in time to the electrolyte or distilled water to the high line. Keep positive and negative battery cables in good contact, and keep the battery clean and dry. Vehicles that have been placed for a long time must take off the positive and negative cables of the battery. After about half an hour or so of reconnecting and starting the engine, about 20 minutes later, if the battery is obviously insufficient, charge it in time.
Sixth, tire inspection Monthly tire pressure should be checked at room temperature, if it is lower than normal standards should be promptly added tire pressure. The pressure cannot be too high or too low, otherwise it will affect the safety of driving.
Check the cracking condition of the tire. When there is a safety hazard, replace the tire in time.
When selecting tires, they should be the same type.
Seventh, the belt examines Starts the engine or usually drives the vehicle, the belt sounds, in one kind of situation is the belt does not check the adjustment to cause for a long time, according to the normal standard adjustment. Another situation is the aging of the belt and it needs to be replaced.
VIII. Inspection of the Air Filter Over-dirty air filter can cause poor engine operation, excessive fuel consumption, and damage to the engine. When checking the air filter, if there is less dust and less light clogging, high pressure air can be used from the inside to the inside. Blow it out and continue to use it. Dirty air filters should be replaced in a timely manner.
Nine, spark plug inspection normal spark plug insulation ceramic intact. There is no crack leakage phenomenon, spark plug gap 0.8 + -0.0mm discharge, the spark is blue, strong. If abnormality is found, adjust the gap or replace the spark plug.
Ten, check the fuel filter if it is found that the fuel is not smooth should check the fuel filter is blocked, such as foreign body blockage should be replaced.