Vertical Free Ball Float Steam Trap (Flanged)

Performance / Advantages:

Continues discharging saturation condensed water without accumulation, and so get the maximum thermal efficiency.
When steam pressure changes, the ball float can adjust the opening of valve seat without influence, and so it is stable.
With automatic and manual releaser, and so its exhaust performance is good without airlock and working is smooth without noise.
 
Application: 

By automation, speediness and continuing features, this valve is used for the steam heating equipment, condensation water recovery system and the place where needs removing condensation water at quick speed, and so stop steam leakage effectively and obtain optimum heating.

Working Principle: 

By the action of buoyancy, the position of floating ball changes with the water level of condensation water and adjust the opening of valve seat automatically, continue to discharge condensation water, when the condensation water stops, the floating ball fall onto bottom by gravity, then close opening of drain valve. The opening of drain valve is below the water lever, and so the water is separated from steam automatically, and form water seal without steam leakage.
 

Main Part	Materal
Body	Carbon Steel
Bonnet	Carbon Steel
Seat	Stainless Steel
Percolator	Stainless Steel

Main Basis for Type Selection: 

Condensation water loading (discharge)kg/h (select the multiplying power 2~3 times).
Maximum working pressure Mpa
Operation pressure differential
Valve material and nominal pressure
Connection mode and dimension
 
Use and Maintenance: 

Confirm the valve material, pressure and check if the maximum is suitable for operation condition.
Before installation, clean the pipeline and clear away sundries.
The installation position shall be closed to heating equipment as much as possible.
Install the minimum point of pipe horizontally and the direction of flow should be the same to the label of valve.
Install steam trap for each heating equipment in case cause influence each other.
under the safe operation of system, open the valve in front of the steam trap, make it rise up to normal station slowly.
Do time-based maintenance for the normal working of steam trap.
 

 

Top Drive Drilling Rig

Main feature of anchor mining drilling machine:
1, The anchor drill rig with full hydraulic control, Operation is convenient and flexible, easy shifting, good maneuverability, saving time and labor.
2, Drill rotary machine driven by a double hydraulic motor, High output torque, rotary center lower than similar products, greatly improving the rig drilling rig stability.
3, New variable angle mechanism to make the hole more convenient, adjustment range is larger, can reduce the requirements of the working surface.
4, For the customer's local special conditions, the cooling system is optimized to ensure that the hydraulic system when the outdoor temperature is 45 ° C, the maximum temperature does not exceed 70 ° C.
5, Match dedicated simultaneous casing drill tools (drill pipe, casing, eccentric bit, etc.), in the unstable formation with casing wall openings, the conventional button bit use for end-hole . High drilling efficiency , and good quality.
6, Machine is mainly suitable for deep foundation pit anchor support, but also through the rotary spray module replacement, so machine can be rotary jet spray construction.

7,The mining drilling machine can meet three-wing drill drilling, DTH hammer drilling, casing drilling, drill pipe / casing complex drilling, single / double/ triple rotary spray, fixed spray, swing spray and so on .

Top Drive Drilling Rig,Top Drive Drilling,Top Drive Rig,Top Drive In Drilling Rig

JIANGSU XI TEC ENVIRONMENTAL&DRILLING EQUIPMENT COMPANY CO.LTD , https://www.xitecdrillingwx.com