The place where the air compressor is placed is very important
Since the machine is still in the industrial test stage, a small air compressor is used in the field. At the beginning, the liquid filling machine runs normally. However, the working time is not long. After about tens of thousands of times, the malfunction is gradually increased. It got up and it didn't work very well soon. After inspection and analysis, it was found that the rubber seals of almost all pneumatic components lost their elasticity and could not play a sealing role. In addition, blind ends such as pneumatic reversing valves and logic components were found. There are many colloidal deposits. After inspection and analysis, the key to finding out the above problems is caused by the place where the air compressor is placed. Because the workshop is filled with volatile gases and is accompanied by a lot of dust, these things are directly sucked into the air compressor and then compressed and used by the equipment. At the same time, the air compressor itself leaks a small amount of lubricating oil and air cools to precipitate condensed water. , mixed together, after a long time, the rubber seal corrosion failure. In response to the above situation, the following two measures were taken immediately: First, the air compressor was removed from the workshop and placed in a well-ventilated cabin to prevent foreign matter from being mixed; Second, a simple filter was designed to strengthen the air source. Purification treatment. After taking the above measures, the existing problems are better solved. The device did not have the above failure during normal operation. From the above examples, the following conclusions can be drawn: the selection of the mass and position of the air compressor itself is very important, which directly affects the quality of the compressed air provided by the air compressor. This in turn affects whether the pneumatic equipment is working properly. It can be seen that the compressed air does not ensure the normal operation of the pneumatic equipment. Round Open Water Cooling Tower The whole structure is solid and light;the body and water pond is manufactured with reinforced glass fibre (FRP glass fiber reinforced plastics),never being corrosive. The surface finish is added with ultraviolet inhibitor,which can resist sunshine attack and damage.
Apply special design PVC water block curtain (water-stop) to prevents plashing) remarkably; pressure drop loss is slight and splashing loss i under 0.001%.
Apply cellular vacuum molding heat dissipation material, stagger arrangement surface has grooves and the heat exchange effect is especially good.
Round Open Water Cooling Tower,Water Cooling Tower,Round Cooling Tower,Cool Water Towers Wuxi Ark Fluid Science Technology Co., Ltd. , https://www.fangzhou-arkfluid.com
All steel and iron material is processed through galvanizing by dipping,Ocorrosion resisting and durable.
Special designed axial-flow type air blower applies belt reduction gear,reducing low noise and sufficient wind; tailor-made water-drop noise
reduction carpet to eliminate water sound.
Water pond applies slant design, easy to wash, containing less water; the operating weight is lower, but the water tank is very big, so it won't absorb air.
The cooling tower support is light and solid, convenient to assembly no matter there is suspension iron rack or not.